Journal ·

Notes from the beginners' warping session

Nine people came to the February session, six of whom had never warped a loom before. Three hours later there were three looms dressed and only one tangle that needed scissors. A good day. These are the notes we handed out, with a few things added from the questions people asked.

Before you start

  1. Work out your numbers on paper first. Width in the reed × ends per inch gives the number of warp ends. Finished length + loom waste (about 50 cm on our table looms) + take-up (around 10%) gives the warp length.
  2. Count in groups. Tie a counting string around every 20 ends on the warping board. Recounting 240 ends because you lost track at 173 is how evenings disappear.
  3. Make a cross, and keep it. The cross keeps the threads in order. Tie it on both sides before you take the warp off the board.

Things people asked

Front to back or back to front? We teach back to front on the club looms because the raddle makes it easy to spread the warp evenly before threading. Both work. Use whichever your hands understand.

How tight should the warp be? Firm, like a drum skin you can still press into. Even tension matters more than tight tension.

What if I miss a heddle? You will. Everyone does. Weave a few picks of plain weave first and the mistake will show itself as a float; it takes two minutes to fix at this stage and much longer later.